Installation Checklist - RevMaster Pro

Installation Checklist - RevMaster Pro

support/revpro2.jpgInstallation Check List - RevMaster Pro

A. Properly align the base bolts through the yellow frame and cross arms

Align the 4 holes in the cross arm with the 4 holes in the frame. Insert a base bolt into the top of each hole in the frame and push the bolt through the cross arm (do not force the bolt through). Finger-thread each of the base bolts, and use the 6 mm hex key and the wrench tool to secure the nut. Once all base bolts are installed, test the bike to make sure that the frame is stable.

 

B. Do not cross thread the pedal arms.

  • Right Pedal:  The right pedal has a normal thread pattern (turn right to tighten, turn left to loosen). Use your fingers to start the pedal, so that you can feel if you start to cross thread the crank arm. Tighten the pedal with a pedal wrench.
  • Left Pedal:  The left pedal has a reverse thread pattern (turn left to tighten, turn right to loosen). Use your fingers to start the pedal, so that you can feel if you start to cross thread the crank arm. Tighten the pedal with a pedal wrench.

 

C. Ensure that the water bottle cage is secured to the handlebar

Secure the water bottle cage to the water bottle cage mount with the 3-mm screw.

 

D. Ensure that there is a brass washer on the seat handle

Position the seat with seat slider over the seat post. Loosely thread a handle with a washer through the seat post into the seat slider. Slide the seat to the desired position and tighten the handle.

 

QUICK REFERENCE CHECK LIST

  1. Rock the Bike
    Is the bike stable? Yes___ No___
    If No, inspect the base bolts and check the bike again.
  2.  

  3. Ride the bike
    Are the pedals loose? Yes___ No___
    If Yes, inspect the pedal arm to ensure that it has not been cross- threaded. If it has, replace the crank arm, install the pedals, and check again.
  4.  

  5. Water Cage
    Is the water bottle cage secured to the handlebar? Yes___ No__
    If No, either tighten the 3-mm mounting screw, or install a water bottle cage
  6.  

  7. Seat
    Is there a brass washer on the seat handle? Yes___ No__
    If No, install a brass washer on the seat handle.
Downoad PDF